EasyManuals Logo
Home>Hypertherm>Water Pump>HyPrecision Predictive P-50S

Hypertherm HyPrecision Predictive P-50S User Manual

Hypertherm HyPrecision Predictive P-50S
231 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
HyPrecision Predictive waterjet pump Operator Manual 810120 33
1 – Terminology
Terminology
static seal
The high-pressure seal at the output end of the high-pressure cylinder; the static seal does not touch the
plunger
Refer to
dynamic seal.
supply water
Water going to the pump from a water softener, a reverse osmosis system, a well, or a public utility
system integrator
An integrator of waterjet cutting systems that are sold directly to end users
technical drawings
System schematics and wiring diagrams that describe the system
total dissolved solids (TDS)
Dissolved solids refers to tiny particles in solution in water. TDS include hard elements such as iron, calcium,
magnesium, and silica, which form deposits in high-pressure tubing and can damage check valves, seals,
orifices, and other consumables.
total suspended solids (TSS)
Suspended solids refers to small, solid particles that are suspended in water. In HyPrecision waterjet pumps,
filters remove these solids from the cutting water.
tube
A flexible, hollow cylinder that is used to move low-pressure fluids; a tube is one piece from end to end
Tubes are sized by outer diameter (OD) and wall thickness (WT or gauge).
Refer to hose, pipe, and tubing.
tubing
A rigid, hollow cylinder that is used to move high-pressure fluids; tubing is one piece from end to end; tubing
typically has push-to-connect fittings
Tubing is sized by outer diameter (OD) and wall thickness (WT or gauge).
Refer to hose, pipe, and tube.
uncontrolled shutdown
The system turns off without completing an established sequence of tasks; this can occur when power is lost
or when the Emergency Stop knob is pushed
Refer to
normal shutdown.
union
A 3-part fitting that is made to join 2 pipes so that only 1 pipe must be turned when removing the union
VAC
Volts of alternating current
valve
A device used to control the rate of a fluid flowing in a pipe or a tube
VDC
Volts of direct current
warning
The controller senses a condition that could cause a problem or a failure

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hypertherm HyPrecision Predictive P-50S and is the answer not in the manual?

Hypertherm HyPrecision Predictive P-50S Specifications

General IconGeneral
BrandHypertherm
ModelHyPrecision Predictive P-50S
CategoryWater Pump
LanguageEnglish

Related product manuals