Hypertherm powermax1100 - Section 3 Setup; Setup

3-1
S ETUP
Operator Manual
Section 3 SETUP
In this section:
Upon Receipt .................................................................................................... 3-2
Claims............................................................................................................... 3-2
Hoisting Requirements ..................................................................................... 3-3
Voltage Configurations...................................................................................... 3-4
Power Cords - 208/240/480V, 200/230/400V and 600V Power Supplies......... 3-5
Power Cords - 230/400V CE Power Supplies .................................................. 3-6
Changing the Strain Relief Sleeve .................................................................... 3-6
Single-Phase and Three-Phase Power Configurations..................................... 3-7
Single-Phase................................................................................................ 3-7
Three-Phase ................................................................................................ 3-7
Power Cord Plugs ............................................................................................. 3-8
Power Requirements ........................................................................................ 3-8
Line Voltage Disconnect Box........................................................................ 3-8
Grounding Requirements.................................................................................. 3-8
Work Cable and Clamp..................................................................................... 3-9
Gas Supply Requirements................................................................................ 3-9
Air Supply Quality......................................................................................... 3-9
Additional Air Filtration ............................................................................... 3-10
Nitrogen Supply Quality ............................................................................. 3-10
Gas Supply Connection .................................................................................. 3-10
Torch Lead Connection................................................................................... 3-11
PAC135M ON/OFF Pendant Connection................................................... 3-11
PAC135M Torch ON/OFF Switch Connection Data ................................... 3-11
PAC135M Torch Alignment ........................................................................ 3-11
Machine Interface with PAC135M................................................................... 3-12
Arc Voltage................................................................................................. 3-13