Hypertherm Powermax30 AIR Operator's Manual

Powermax30 AIR Operator Manual 808840 61
Section 6
Parts
Use the part and kit numbers in this section to order consumables, accessories, and external replacement parts for your
power supply and hand torch.

For instructions on installing the consumables in the hand torch, see Step 1 – Install the
consumables on page 41.
This system contains no customer serviceable parts inside the power supply or inside the hand torch. For assistance with
repairing or replacing internal components:
1. Call your Hypertherm distributor or authorized Hypertherm repair facility.
2. Call the nearest Hypertherm office listed in the front of this manual.

Hypertherm Powermax30 AIR Specifications

General

Built-in Air Compressor	Yes
Output Voltage	83 VDC
Input Voltage	120-240 V
Current Output	15–30 A
Cutting Thickness	Up to 10 mm (3/8 in) recommended cut
Gas Supply	Built-in air compressor
Operating Temperature	-10°C to +40°C (+14°F to +104°F)