Hypertherm Powermax45 XP - Page 15

Machine Interface Receptacle with Voltage Divider Board
Powermax45 XP Field Service Bulletin 809940 15
3. Put the cover on the plasma power
supply. Align the louvers in the cover with
the fan . Make sure that none of the
cables are pinched.
4. Install the handle as follows:
a. Align the handle with the holes in
the cover.
b. Put the ends of the handle below the
edges of the front and rear panels .
c. Install the 2 screws that attach the
handle and cover to the plasma
power supply.
5. Install the 2 screws that attach the
bottoms of the front and rear panels to
the plasma power supply.
6. Connect the gas supply.
7. Connect the power cord to the
power source.
4
5
6
7
7
8
8
9
9
4
5
6
7
8
9