Hypertherm Powermax45 XP - Disconnect the internal components

Machine Interface Receptacle with Voltage Divider Board
Powermax45 XP Field Service Bulletin 809940 7
Disconnect the internal components
1. Remove the protective cover from the rear panel. Push on the tabs on the inside of the
protective cover to remove it.
2. Remove the gas supply hose from the
push-to-disconnect fitting on the right
side of the solenoid valve.
3. Remove the looped gas supply hose
from the push-to-disconnect fitting on the
air filter.
4. Move the ground clip off of the rear
panel. Keep the ground wire connected to the
ground clip.
1
2
1
2
4
3
3
4
5
5