Hypertherm Powermax45 XP Field Service Bulletin

Machine Interface Receptacle with Voltage Divider Board
6 809940 Field Service Bulletin Powermax45 XP
5. Remove the 2 plastic pins that attach the component barrier to the power PCB.
6. Lift the component barrier off of the plasma power supply.
7. Disconnect the front and rear panels. Use a blade screwdriver to push in the 2 tabs at the
bottom of each of the panels until the panels disconnect from the base.
5
6
6
5

Hypertherm Powermax45 XP Specifications

General

Output Current	10-45 A
Gas Supply	Clean, dry, oil-free air or nitrogen
Torch Style	Handheld or mechanized
Input Voltage	50/60 Hz
Cutting Thickness	12 mm (1/2")
Cutting Capacity	16 mm (5/8 in)
Recommended Gas Inlet Flow Rate/Pressure	6.2 bar