Hytera DMR System Planner
125
2) Controlling a remote equipment
Controlling a remote device
Source radio:
1) Send the control command to a radio or a group of radios. This command can
cause the specified GPIO Pin to output active/inactive voltage, to toggle the voltage
or to output pulse, enabling you to control the remote device.
2) Receive the control response from target radio to get the control result.
Target radio:
1) Receive the control command.
2) Perform the requested command on the telemetry device.
3) Send operation result to the source radio. However, no reply will be given if the
control command is sent via group call.
This feature allows you to control a device remotely such as opening an automatic
door remotely.
To Next Page
Loading...
Need help?
General
