Hytera DMR System Planner
126
3) Uploading the status of telemetry device
Uploading the status of remote telemetry device
Source radio:
1) Change in telemetry equipment status would cause the terminal GPIO status to
change, which will trigger the source radio to upload its GPIO status.
2) Send Status w/Text Command to send its GPIO status to the target radio.
Target radio:
1) Receive Status w/Text Command to get the status of telemetry device, and
display and save the received message.
2) Send operation result to the source radio. However, no reply will be given if the
control command is sent via group call.
You can also use this feature to get the status of your desired device remotely such
as the door. In addition, you can use the related telemetry command to control the
device connected with the target radio. For example, you can connect the target
radio with an automatic door. Then send a telemetry command to the target radio to
trigger an emergency alarm when the door is opened.
To Next Page
Loading...
Need help?
General
