Hytera DMR System Planner
68
5. If B sends a message to C, A will receive the interrupt command and be
interrupted after it decodes the command. Then it will be prompted “Call
Interrupted”. C will be prompted that the call is over and get the message from
B.
Emergency Priority Interrupt Application
Configuration Requirements:
1. The interrupting subscriber, Subscriber B, must enable Priority Interrupt Encode
on the current channel.
2. Subscriber A, the interrupted subscriber, must have the enabled Priority
Interrupt Decode option on the current channel.
3. Both the subscribers are on the same channel, using Pseudo Trunk and
meeting the requirements on TX Admit settings.
4. Subscriber B, the interrupter, must have the Emergency Priority Interrupt
enabled.
See Figure 2.8.2-5 for the application example.
Figure 2.8.2-5: Emergency Priority Interrupt Application
1. Subscriber A is transmitting voice signals in communication with B and C in
Group Call 1.
2. Subscriber B transmits an Emergency Alarm.
To Next Page
Loading...
Need help?
General
