Hytera DMR System Planner
69
3. After receiving and decoding the Priority Interrupt command, Subscriber A will
be interrupted and prompted “Call Interrupted” on its main interface. And then it
will receive the Emergency Alarm from B.
4. Subscriber C will be prompted that the call is over and get the alarm from B.
5. After transmitting the interrupt, B can make Emergency Call via PTT key. It will
not be prompted “Interrupt Success” during the transmission of the interrupt.
The subscriber, A or C, which selects the Emergency Alarm Ack option, will
automatically acknowledge when it receives the emergency number. It is suggested
to enable only one subscriber to make Ack operation on the channel.
Radio Disable Priority Interrupt Application
Configuration Requirements:
1. The interrupting subscriber, Subscriber B, must enable Priority Interrupt Encode
on the current channel.
2. Subscriber A, the interrupted subscriber, must have the enabled Priority
Interrupt Decode option on the current channel and the enabled Radio Disable
Decode.
3. oth the subscribers are on the same channel, using Pseudo Trunk and meeting
the requirements on TX Admit settings.
4. ubscriber B, the interrupter, must have the Radio Disable Priority Interrupt
enabled.
See Figure 2.8.2-6 for the example.
Figure 2.8.2-6: Radio Disable Priority Interrupt Application
To Next Page
Loading...
Need help?
General
