Hytera DMR System Planner
70
1. Subscriber A is transmitting voice signals in communication with B and C in
Group Call 1.
2. Subscriber B initiates the Radio Disable, targeting at Subscriber A or another.
The target subscriber must select Radio Disable Priority Interrupt option apart
from setting the Priority Interrupt parameters.
3. After receiving and decoding the Priority Interrupt command, Subscriber A will
be interrupted and prompted “Call Interrupted” on its main interface. Then it will
receive the Radio Disable command from B, and be disabled after decoding the
command.
4. Subscriber C is prompted that the call is over.
5. If B doesn’t receive the ACK from A, it will try to transmit the Radio Disable
command again, but not the Priority Interrupt one.
6. If B sends the Radio Disable command to C, A will receive the interruption
command and be interrupted after it decodes the command. Then it will be
prompted “Call Interrupted”. C will be prompted that the call is over, get the
Radio Disable command from B and be disabled after decoding the command.
To Next Page
Loading...
