LOWER TORQUE LIMIT; he
default Unlock Code is 0 (to
change the unlock code see
“change unlock code” option
on page 26).
CALIBRATION LIMIT: The user can specify the number
of operations the gun can perform before it needs to be
calibrated. When this number of operations is exceeded
the gun will warn the operator before each subsequent
operation. If set to zero this feature is disabled.
SET ANGLE DELAY: The user can adjust the time delay
between the gun reaching torque and when it starts turning
through the specied angle. This is the time that the tool
will pause between the Torque and Angle Operations.
CALIBRATION SAMPLES: The user can set the
number of Calibration Samples to take per calibration
point. See the “Calibration” section of the manual.
Options (Continued)
27
BREAKTHROUGH PRODUCTS FOR INDUSTRIAL BOLTING
To Next Page
Loading...
Need help?
General
