70
Network Camera User Manual
3.
Configure the SNMP settings.
Note: The settings of the SNMP software should be the same as the settings you
configure here.
4.
Click Save to save and finish the settings.
Notes:
• A reboot is required for the settings to take effect.
• To lower the risk of information leakage, you are suggested to enable SNMP v3 instead
of SNMP v1 or v2.
7.2.2
Configuring FTP Settings
Purpose:
You can configure the FTP server related information to enable the uploading of the captured
pictures to the FTP server. The captured pictures can be triggered by events or a timing
snapshot task.
Steps:
1.
Enter the FTP Settings interface: Configuration > Network > Advanced Settings >
FTP.
Figure 7-10 FTP Settings
To Next Page
Loading...