3. Operation
Fieldbus Communication
80
RCP6
3.2 Initial Setting
Use Gateway Parameter Setting Tool (Ver. 2.4.1.0 or later) in order to perform the setting for
Operation Mode.
Caution: Although the parameter settings of RCP6S Gateway Unit can be conducted on
Gateway Parameter Setting Tool (Ver. 2.2.0.0 or later), as the setting and
cancellation of the left-justification setting feature can only be conducted in Ver.
2.4.1.0 or later, setting conducted on the tool with Ver. 2.2.0.0 to Ver. 2.4.1.0 may
cause unexpected operation.
Shown below is the process for the setup. Follow the instruction to conduct the setting properly.
Refer to [3.8 About Gateway Parameter Setting Tool] for details.
(Preparation) Install RC PC Software and Gateway Parameter Setting. For Gateway
Parameter Setting Tool, install the file stored in the CD-ROM for PC software,
or download from our website, intelligentactuator.com.
[Refer to the instruction manual of the PC software for the details of the PC
software.]
Make sure the system I/O connector wires and operation mode setting switch are in MANU
condition when having the setting done. [Refer to 2. RCP6S Gateway Unit 6), 7)]
3.2.1 Operation Mode Setting (Setting in Gateway Parameter Setting Tool)
[Step 1] Connect between the PC and SIO connector on RCP6S Gateway Unit with the cable
enclosed in the RC PC Software, or connect the USB connector by USB cable
connection and start the gateway parameter setting tool.
The following window appears. Select “RCP6 GW” and click “OK”.
To Next Page
Loading...
Need help?
General
