IBM 1 Series - Page 89

Because the socket adapter is designed primarily for use by a technical
expert, the customer is responsible for the operation of the design. To
achieve adequate results, good design practices—both electrical and
mechanical—must be adhered to. Components are to be no higher than 11
mm (0.440 in) from the surface of the card. No more than 15 watts are to
be dissipated on the card. Only logic voltages should be used (less than 24
volts dc) to avoid safety problems. The customer is responsible to evaluate
the exposure to the vibrational forces or translational forces caused by any
customer cables that may be attached to the card. The card size used must
be specified.
IBM BEARS NO RESPONSIBILITY for customer logic or hardware.
-
DO02 A
D13
J02
Ll
TL
VA
NAA
BO1 |
Ke
DO1 J13 183 mm
PO2 7.21 in
SN
P13
»
KECK
MILLION
OLY”
YER U02
L¢
U13 v
WMD
h®P
VAS 36
836
VY
S
we
IBM
card
2
SS
ff
72-pin
connector
~D36
H/
‘
TT
——\
Customer
card
Figure 2-34. Socket adapter and customer card
2-78 GA34-0033