Diagnostic Aids 3-7
To Load the Diagnostics Diskette
1. Power-off the system unit.
2. Insert the bootable PC-Doctor for DOS diskette with drivers in drive A.
3. Power-on the system unit.
4. Do not press F1 during POST.
5. If any POST errors appear after POST, make a note of the errors and
press the <Enter> key to continue.
6. DOS should load.
7. During boot, verify that each driver loads successfully. For drivers that do
not load successfully, verify that the device the driver is associated with it
is installed properly.
8. PC-Doctor for DOS will load
To Next Page
Loading...
