2-28
Memory
001 - START
− Power-off the system unit.
− Insert the a Bootable Diagnostics Diskette into the diskette drive.
− Ensure all SIMMs are seated correctly.
− Power-on the system unit.
− Note any messages, error codes, or symptoms.
002 - DO YOU RECEIVE POST MEMORY ERROR MESSAGE?
(YES, READ AHEAD. NO, GO TO STEP 003)
− Enter BIOS Setup then reboot system.
003 - DOES THE POST ERROR MESSAGE STILL REMAIN? (YES,
GO TO STEP 005. NO, READ AHEAD. )
− Follow the screen instructions to run the Memory tests.
− If you cannot run the memory test or the test does not find a
problem, use the following procedure to find the failure.
Replace each SIMM, one at a time, with a known, correctly-working
SIMM of the same size and type. If the problem goes away, the last
SIMM replaced is defective. If all SIMMs, on the system board,
have been replaced and the problem remains, replace the system
board.
004 - DOES THE MEMORY TESTS COMPLETE WITHOUT AN
ERROR? (YES, READ AHEAD. NO, GO TO STEP 005.)
− The system memory is now functioning correctly. If you suspect an
intermittent problem, run the Memory test multiple times.
− End
005 -
− Replace each SIMM, one at a time, with a known, correctly-
working, SIMM of the same size and type.
− If the problem goes away, the last SIMM replaced is defective. If
all SIMMs on the system board, have been replaced and the
problem remains, replace the system board.
− Go to 001.
To Next Page
Loading...
Need help?
General