IBM Aptiva Series - Hard Disk Drive; 3.5 Hard Disk Drive Jumper Settings

Parts/Test Point Locations 5-11
Hard Disk Drive
Figure 5- 8 3.5” Hard Disk Jumper Settings Layout
3.5” Hard Disk Drive Jumper Settings
The configuration of the following four jumpers controls the drive’s mode of
operation:
• DS – Drive Select
• CS/ SP– Cable Select / Slave Present
Table 5-7 3.5” Hard Disk Drive Jumper Settings
DS CS/SP NOT USED DESCRIPTION
On Off -- Drive configured as a Master.
Off Off -- Drive configured as a Slave.
On On -- Drive configured as a Master, with an
attached Slave