IBM DS4800 - Appendix C. Rack Mounting Templates

Appendix C. Rack mounting templates
This appendix provides duplicate copies of the rack mounting templates. If you want
to tear out the templates from this document for easier use, use these copies rather
than those provided in “Installing the support rails” on page 32.
Use the following templates (Figure 101 on page 182 and Figure 102 on page 183)
to identify the proper locations for inserting M5 screws when mounting the support
rails and DS4800 in a rack cabinet. The locations for the M5 screws are highlighted
in the templates.
The DS4800 is 4 U high. Align the template with the rack at a U boundary. U
boundaries are shown as horizontal dashed lines in the rack mounting templates.
Note: The mounting holes that are shown in the following templates are square.
The holes in your rack cabinet might be round or square.
© Copyright IBM Corp. 2006 181