Or:
ledctl locate_off=/dev/rsnvmeX
• To prepare a drive for removal (spinning disks only):
storcli /cx[/ex]/sx spindown
3. Unlock the drive bay handle (B) by pushing the handle release (A) down. The handle (B) snaps out
towards you. If the handle does not snap out all the way, the drive does not slide out of the system.
See the following gure.
Figure 7. Removing a drive
4. Support the bottom of the drive as you slide it out of the system. Do not hold the drive by the handle.
5. If you are removing more than one drive, repeat the steps in this procedure until all drives are
removed.
Replacing a front hard disk drive or solid-state drive in the 9183-22X system
To replace a front hard disk drive or solid-state drive, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
Removing and replacing parts in the 9183-22X
11
To Next Page
Loading...
