Table 5. NetWare driver messages for the Ethernet controller (continued)
Message Description
Requested number of Secondary
cards are not found.
Explanation: The number of adapters specified in the bind command could
not be located.
Action: Verify the numbers and slot locations of the adapters to be bound. If
the problem persists, contact your network administrator.
Failed to create AFT group. Make
sure that the drivers for supported
adapters are loaded, primary adapter
is bound to protocols, and secondary
adapter is not bound to any
protocols.
Explanation: Binding of protocol failed. Protocol is either not bound to any
adapter or is bound to more than one adapter in the group.
Action: Ensure that the protocol is bound to only adapter in an AFT team.
Error identifying slot numbers for the
specified board names.
Explanation: The mapping between the board name entered and the slot
number for an adapter could not be established.
Action: Check the board name for the adapter before issuing the bind
command. If the problem persists, contact your network administrator
Can’t unbind specified slot from AFT
group. Make sure that the slot you
specified is for the primary adapter
in an AFT group.
Explanation: The number entered in the unbind command was not the
primary adapter in an AFT group.
Action: Reissue the unbind command and specify the slot number for the
primary adapter
LAN adapter at slot nnnn (Port 0xaa)
failed to reset. Check the state of the
adapter.
Explanation: The adapter that you specified could not be initialized.
Action:
1. Load the driver for the supported adapter.
2. Check that the adapter is seated properly in the slot and try loading the
AFT module again.
If the problem persists, contact your network administrator.
AFT is not supported on this version
of NetWare.
Explanation: The NetWare on your computer is not a version supported by
AFT.
Action: Load and bind AFT only on supported versions of NetWare
(currently version 4.11 and above).
Failed to allocate resources tags. Explanation: An unknown error has occurred when trying to allocate
needed resources for the AFT module.
Action: Check computer configuration. If the problem persists, contact your
network administrator.
Please unload all LAN drivers before
unloading AFT.NLM.
Explanation: An attempt was made to unload the AFT.NLM module before
unloading the adapter driver.
Action: Unload the adapter driver before unloading the AFT module.
66 IntelliStation M Pro: User Guide
To Next Page
Loading...
Need help?
General
