NDIS 4.0 (Windows NT and 2000) driver messages
This section contains the error messages for the NDIS 4.0 drivers. The explanation
and recommended action are included with each message.
Table 6. NDIS (Windows NT or Windows 2000) driver messages for the Ethernet controller
Error code (hex) Description
0x00 Explanation: The driver could not register the specified interrupt.
Action: Contact your network administrator.
0x01 Explanation: One of the PCI cards did not get the required resources.
Action: Contact your network administrator.
0x02 Explanation: Bad node address (multicast address).
Action: Make sure the locally administered address is valid, if one is specified. The address can
not be a multicast address.
0x03 Explanation: Failed self-test.
Action: Make sure a cable is attached to the Ethernet connector. If the problem persists, call for
service.
0x0D Explanation: Could not allocate enough memory for transmit queues.
Action:
1. From the Windows NT desktop, select Start→Control Panel→Networks→Adapters.
2. Select your IBM Ethernet adapter from the list.
3. Select Properties→Advanced.
4. Lower the resource values that apply to the transmit queue.
0x0E Explanation: Could not allocate enough memory for receive queue.
Action:
1. From the Windows NT desktop, select Start →Control Panel→Networks→Adapters.
2. Select your IBM Ethernet adapter from the list.
3. Select Properties→Advanced.
4. Lower the resource values that apply to the receive queue.
0x0F Explanation: Could not allocate enough memory for other structures.
Action:
1. From the Windows NT desktop, select Start→Control Panel→Networks→Adapters.
2. Select your IBM Ethernet adapter from the list.
3. Select Properties→Advanced.
4. Lower the value for the resource named in the message.
0x10 Explanation: Did not find any Ethernet controllers.
Action: Contact your network administrator.
0x11 Explanation: Multiple Ethernet controllers found, but none matched the required ID.
Action: Contact your network administrator.
0x13 Explanation: Did not find any Ethernet controllers that matched the required subven/subdev.
Action: Contact your network administrator.
0x16 Explanation: Single adapter found, but multiple instances tried to load.
Action: Contact your network administrator.
Chapter 6. Solving problems 67
To Next Page
Loading...
