Table 19. C2001000 to C20082FF checkpoints (continued)
v If the system hangs on a progress code, follow the suggested actions in the order in which they are listed in
the Action column until the problem is solved. If an action solves the problem, you can stop performing the
remaining actions.
v See Chapter 3, “Parts listing, Type 8406,” on page 229 to determine which components are CRUs and which
components are FRUs.
Progress code Description Action
C2006030 Priming LP configuration LID
1. Go to “Recovering the system firmware” on
page 220.
2. Replace the system-board, as described in
“Replacing the FRU system-board and
chassis assembly” on page 260.
C2006040 Preparing to initiate LID load from load
source
1. Go to “Recovering the system firmware” on
page 220.
2. Replace the system-board, as described in
“Replacing the FRU system-board and
chassis assembly” on page 260.
C2006050 LP configuration LID primed
successfully
1. Go to “Recovering the system firmware” on
page 220.
2. Replace the system-board, as described in
“Replacing the FRU system-board and
chassis assembly” on page 260.
C2006060 Waiting for LID load to complete
1. Go to “Recovering the system firmware” on
page 220.
2. Replace the system-board, as described in
“Replacing the FRU system-board and
chassis assembly” on page 260.
C2006100 LID load completed successfully
1. Go to “Recovering the system firmware” on
page 220.
2. Replace the system-board, as described in
“Replacing the FRU system-board and
chassis assembly” on page 260.
C2006200 Loading raw kernel memory image
1. Go to “Recovering the system firmware” on
page 220.
2. Replace the system-board, as described in
“Replacing the FRU system-board and
chassis assembly” on page 260.
C20062FF Loading raw kernel memory image
completed successfully
1. Go to “Recovering the system firmware” on
page 220.
2. Replace the system-board, as described in
“Replacing the FRU system-board and
chassis assembly” on page 260.
C2008040 Begin transfer slot locks to partition
1. Go to “Recovering the system firmware” on
page 220.
2. Replace the system-board, as described in
“Replacing the FRU system-board and
chassis assembly” on page 260.
Chapter 2. Diagnostics 99
To Next Page
Loading...
