IBM Power PS700 Problem Determination And Service Guide

Table 21. CA000000 to CA2799FF checkpoints (continued)
v If the system hangs on a progress code, follow the suggested actions in the order in which they are listed in
the Action column until the problem is solved. If an action solves the problem, you can stop performing the
remaining actions.
v See Chapter 3, “Parts listing, Type 8406,” on page 229 to determine which components are CRUs and which
components are FRUs.
Progress code Description Action
CA00E1D3 Create SCSD block device node (SD)
1. Go to “Checkout procedure” on page 184.
2. Replace the system-board, as described in
“Replacing the FRU system-board and
chassis assembly” on page 260.
CA00E1D4 Create SCSD byte device node (ST)
1. Go to “Checkout procedure” on page 184.
2. Replace the system-board, as described in
“Replacing the FRU system-board and
chassis assembly” on page 260.
CA00E1DC Dynamic console selection
1. Verify the video session and the SOL
session. The console might be redirected to
the video controller.
2. Start a remote control session or access the
local KVM to see the status.
3. Go to “Checkout procedure” on page 184.
4. Replace the system-board, as described in
“Replacing the FRU system-board and
chassis assembly” on page 260.
CA00E1DD A graphics adapter has been selected as
the firmware console, but the USB
keyboard is not attached.
1. Verify that there is a USB keyboard
attached to a USB port that is assigned to
the partition.
2. If the problem persists:
a. Go to “Checkout procedure” on page
184.
b. Replace the system-board, as described
in “Replacing the FRU system-board
and chassis assembly” on page 260.
CA00E1F0 Start out-of-box experience
1. Go to “Checkout procedure” on page 184.
2. Replace the system-board, as described in
“Replacing the FRU system-board and
chassis assembly” on page 260.
CA00E1F1 Start self test sequence on one or more
devices
1. Go to “Checkout procedure” on page 184.
2. Replace the system-board, as described in
“Replacing the FRU system-board and
chassis assembly” on page 260.
CA00E1F2 Power on password prompt
1. Go to “Checkout procedure” on page 184.
2. Replace the system-board, as described in
“Replacing the FRU system-board and
chassis assembly” on page 260.
CA00E1F3 Privileged-access password prompt
1. Go to “Checkout procedure” on page 184.
2. Replace the system-board, as described in
“Replacing the FRU system-board and
chassis assembly” on page 260.
114 Power Systems: Problem Determination and Service Guide for the IBM Power PS700 (8406-70Y)

IBM Power PS700 Specifications

General

Brand	IBM
Model	Power PS700
Category	Server
Language	English