Table 16. BA000010 to BA400002 Partition firmware SRCs (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved. If an action solves the problem, then you can stop performing the remaining actions.
v See Chapter 3, “Parts listing, Type 8406,” on page 229 to determine which components are CRUs and which
components are FRUs.
Error code Description Action
BA010005 File transmission (TFTP) failed Perform the following actions that checkpoint
CA00E174 describes:
1. Verify that:
v The bootp server is correctly configured;
then, retry the operation.
v The network connections are correct;
then, retry the operation.
2. If the problem persists:
a. Go to “Checkout procedure” on page
184.
b. Replace the system-board, as described
in “Replacing the FRU system-board
and chassis assembly” on page 260.
BA010006 The boot image is too large Start up from another device with a bootable
image.
BA010007 The device does not have the required
device_type property.
1. Reboot the blade server.
2. If the problem persists:
a. Go to “Checkout procedure” on page
184.
b. Replace the system-board, as described
in “Replacing the FRU system-board
and chassis assembly” on page 260.
BA010008 The device_type property for this device
is not supported by the iSCSI initiator
configuration specification.
1. Reboot the blade server.
2. If the problem persists:
a. Go to “Checkout procedure” on page
184.
b. Replace the system-board, as described
in “Replacing the FRU system-board
and chassis assembly” on page 260.
BA010009 The arguments specified for the ping
function are invalid.
The embedded host Ethernet adapters (HEAs)
help provide iSCSI, which is supported by
iSCSI software device drivers on either AIX or
Linux. Verify that all of the iSCSI configuration
arguments on the operating system comply
with the configuration for the iSCSI Host Bus
Adapter (HBA), which is the iSCSI initiator.
BA01000A The itname parameter string exceeds the
maximum length allowed.
The embedded host Ethernet adapters (HEAs)
help provide iSCSI, which is supported by
iSCSI software device drivers on either AIX or
Linux. Verify that all of the iSCSI configuration
arguments on the operating system comply
with the configuration for the iSCSI Host Bus
Adapter (HBA), which is the iSCSI initiator.
Chapter 2. Diagnostics 53
To Next Page
Loading...
