IBM SAN Volume Controller 2145-SV1 - Page 12

124. Location of the FIB cover..................................................................................................................... 113
125. Loosen the FIB screws ........................................................................................................................ 114
126. Remove the FIB from the chassis........................................................................................................ 114
127. FIB parts removed from the chassis....................................................................................................115
128. Removing the display panel assembly.................................................................................................117
129. Display panel assembly........................................................................................................................118
130. Display panel assembly........................................................................................................................120
131. Installing the display panel assembly..................................................................................................121
132. Remove the rail assembly from the front frame bracket.................................................................... 121
133. Remove the rail assembly from the rear frame bracket......................................................................122
134. SAS cable connector orientation..........................................................................................................122
135. Pushing the SAS cable latch closed..................................................................................................... 123
136. Connecting the SAS cables...................................................................................................................124
137. SAS port orientation on expansion enclosures....................................................................................126
138. Features on the front of the 2145-92F expansion enclosure............................................................. 127
139. Secure power cables ........................................................................................................................... 128
140. Power and SAS cable connections on the back of the enclosure .......................................................128
141. Features on the rear of the 2145-92F expansion enclosure.............................................................. 129
142. LEDs on the front of the expansion enclosure.....................................................................................130
143. LEDs on the front of a power supply unit.............................................................................................131
144. LEDs on a drive assembly ....................................................................................................................132
145. LEDs on a secondary expansion module............................................................................................. 133
146. LEDs on the back of the expansion enclosure..................................................................................... 134
147. LEDs on the back of the expansion canister........................................................................................ 134
148. Technician port..................................................................................................................................... 140
xii