19 19 461300 -- N16 No_Module FC
20 20 461400 -- N16 No_Module FC
21 21 461500 -- N16 No_Module FC
22 22 461600 -- N16 No_Module FC
23 23 461700 -- N16 No_Module FC
24 24 461800 -- -- Online VE VE-Port 10:00:00:05:1e:65:77:04 "sb_71" (upstream)
25 25 461900 -- -- Offline VE
26 26 461a00 -- -- Offline VE
27 27 461b00 -- -- Offline VE
28 28 461c00 -- -- Offline VE
29 29 461d00 -- -- Offline VE Disabled (10VE Mode)
30 30 461e00 -- -- Offline VE Disabled (10VE Mode)
31 31 461f00 -- -- Offline VE Disabled (10VE Mode)
32 32 462000 -- -- Offline VE Disabled (10VE Mode)
33 33 462100 -- -- Offline VE Disabled (10VE Mode)
34 34 462200 -- -- Offline VE
35 35 462300 -- -- Offline VE
36 36 462400 -- -- Offline VE
37 37 462500 -- -- Offline VE
38 38 462600 -- -- Offline VE
39 39 462700 -- -- Offline VE Disabled (10VE Mode)
40 40 462800 -- -- Offline VE Disabled (10VE Mode)
41 41 462900 -- -- Offline VE Disabled (10VE Mode)
42 42 462a00 -- -- Offline VE Disabled (10VE Mode)
43 43 462b00 -- -- Offline VE Disabled (10VE Mode)
ge0 -- 40G Online FCIP
ge1 -- 40G No_Module FCIP
ge2 -- 10G No_Sync FCIP
ge3 -- 10G Online FCIP
ge4 -- 10G No_Module FCIP
ge5 -- 10G No_Sync FCIP
ge6 -- 10G Online FCIP
ge7 -- 10G Online FCIP
ge8 -- 10G Online FCIP
ge9 -- 10G Online FCIP
ge10 -- 10G Online FCIP
ge11 -- 10G Online FCIP
ge12 -- 10G Online FCIP
ge13 -- 10G No_Module FCIP
ge14 -- 10G No_Module FCIP
ge15 -- 10G No_Module FCIP
ge16 -- 10G Online FCIP
ge17 -- 10G Online FCIP
4. Verify the correct operation of the switch in the fabric by entering
thefabricShow command from the workstation. This command provides general
information about the fabric.
5. Back up the switch configuration to an FTP server by entering the
configUpload command and following the prompts as shown in the example
below.
sb_70:admin> configupload
Protocol (scp, ftp, local) [ftp]:
Server Name or IP Address [host]: 192.168.0.100
User Name [user]: anonymous
Path/Filename [<home dir/config.txt]:
Section (all|chassis|switch [all]): all
configUpload complete: All selected config parameters are uploaded
This command uploads the switch configuration to the server, making it
available for downloading to a replacement switch if necessary.
IBM recommends backing up the configuration regularly to ensure that a complete
configuration is available for downloading to a replacement switch. For specific
instructions about how to back up the configuration, refer to the Fabric OS
30 SAN42B-R Installation, Service, and User Guide
To Next Page
Loading...
Need help?
General