CAUTION:
Never remove the cover on a power supply or any part that has the following
label attached.
Hazardous voltage, current, and energy levels are present inside any
component that has this label attached. There are no serviceable parts inside
these components. If you suspect a problem with one of these parts, contact
a service technician.
Hot-swap
power supply 2
Power supply
filler panel
To install an ac power supply, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 40.
2. Remove the power-supply blank from the empty power-supply bay by pinching
the side clip and pulling the power-supply blank from the bay. Save the
power-supply blank in case you remove the power supply at a later time.
Important: During normal operation, each power-supply bay must contain
either a power supply or power-supply blank for proper cooling.
3. If you are adding a power supply to the server, attach the redundant power
information label that comes with this option on the server cover near the
power supplies.
116 System x3650 M4 Type 7915: Installation and User’s Guide
To Next Page
Loading...
Need help?
General