– POST Event Viewer
Select this choice to enter the POST event viewer to view the POST error
messages.
– System Event Log
Select this choice to view the IMM system event log.
– Clear System Event Log
Select this choice to clear the IMM system event log.
v User Security
Select this choice to set, change, or clear passwords. See “Passwords” for more
information.
This choice is on the full and limited Setup utility menu.
– Set Power-on Password
Select this choice to set or change a power-on password. See “Power-on
password” on page 229 for more information.
– Clear Power-on Password
Select this choice to clear a power-on password. See “Power-on password”
on page 229 for more information.
– Set Administrator Password
Select this choice to set or change an administrator password. An
administrator password is intended to be used by a system administrator; it
limits access to the full Setup utility menu. If an administrator password is set,
the full Setup utility menu is available only if you type the administrator
password at the password prompt. For more information, see “Administrator
password” on page 229.
– Clear Administrator Password
Select this choice to clear an administrator password. For more information,
see “Administrator password” on page 229.
v Save Settings
Select this choice to save the changes that you have made in the settings.
v Restore Settings
Select this choice to cancel the changes that you have made in the settings and
restore the previous settings.
v Load Default Settings
Select this choice to cancel the changes that you have made in the settings and
restore the factory settings.
v Exit Setup
Select this choice to exit from the Setup utility. If you have not saved the
changes that you have made in the settings, you are asked whether you want to
save the changes or exit without saving them.
Passwords
From the User Security menu choice, you can set, change, and delete a power-on
password and an administrator password. The User Security choice is on the full
Setup utility menu only.
If you set only a power-on password, you must type the power-on password to
complete the system startup and to have access to the full Setup utility menu.
An administrator password is intended to be used by a system administrator; it
limits access to the full Setup utility menu. If you set only an administrator
228 System x3200 M3 Types 7327 and 7328: Problem Determination and Service Guide
To Next Page
Loading...
Need help?
General
