Ice Torus 126 Getting Started Guide

6.3-4
‘User friendly’ locking handles on the mounting bracket allow the position of the ICE Torus
printer to be quickly and easily adjusted during production set up.
The upright pole of the bracket may be angled up to +/- 30 degrees from the vertical axis
(The Y axis on the picture above) to accommodate inclined conveyors. This is a rotation of
the printer about the Z axis, in the X-Y plane.
The printer must not be pitched up or down in the opposite direction (i.e. a rotation about the
X axis in the Y-Z plane)

Ice Torus 126 Specifications

General

Brand	Ice
Model	Torus 126
Category	Printer
Language	English