8.4-1
8.4 Powering up a ICE Torus 500
Switch on the printer at the power switch on the rear of the unit.
Figure 8.4-1
The printer will perform a number of self-diagnostic checks during ‘boot-up’ which takes
approximately 90 seconds to complete.
During this period, the CLARiTY™ controller screen first displays an initial set of diagnostic
data, which should be ignored, then a period in which the screen is entirely blank, a
‘CLARiTY™ Initialising System…” message will then be displayed.
Power Switch
To Next Page
Loading...
Need help?
General
