Ice Torus 126 - Encoder Mode

11.2-1
11.2 ‘Encoder’ mode
When encoder mode is selected, the ICE Torus printer will monitor the speed of the
conveyor via the encoder. Therefore, no speed parameters need to be entered at
CLARiTY™.
- Encoder mode is selected via CLARiTY™ Configuration Manager, as shown below in
Figure 11.2-1 .
- In CLARiTY™ Configuration Manager select ‘Encoder Mode’ and select if a single phase
or quadrature encoder is being used.
- Change the ‘Fixed Speed Printing’ parameter to ‘No’, save the parameter changes and
download to the ICE Torus printer.
Figure 11.2-1