6.3-1
6.3 Mounting Considerations
6.3.1 ICE Torus 126
The ICE Torus 126 is shipped ‘dry’, i.e. all ink has been drained from the system after final
test.
In the shipped/dry state, the printer can be freely handled and positioned in any orientation.
However, extreme care should be taken around the printhead area during handling.
The printhead is designed to only operate in a vertical orientation and once filled with ink,
care must be taken to ensure that it is kept in its upright position.
The upright position presents a 17mm vertical printhead array, which is designed to print onto
vertical substrates, e.g. side wall of a cardboard case or tray.
Mounting holes are provided on the printer sidewall, indicated in Figure 6-3.1 below, for
securing to a conveyor.
The part number for the mounting bracket - 402283
ICE Torus 126 outline dimensions can be viewed in the Technical Guide
Figure 6.3-1
ICE Torus
126
To Next Page
Loading...