7.5-1
7.5 Priming a ICE Torus 126
PLEASE NOTE: The priming operation is essential to the on-going performance of the printer
and the procedure must be carefully followed.
Ensure a new can of ink has been added to the printer and that the internal reservoir has
been filled. The reservoir level can be viewed on the home page of CLARiTY™.
Check the air pressure is set to 2.5 Bar.
Navigate to Tools>Setup>Consumables
Select ‘Prime Printhead’ and CLARiTY™ will display the priming screens designed to guide
you through the process.
Figure 7.5-1
To Next Page
Loading...