To Next Page

To Previous Page

14-2

Alternatively, this parameter can be changed in CLARiTY™ Configuration Manager as shown

below in Figure 14.1-2.

Figure 14.1-2

Change the ‘Cleaning Cycle Every N Prints’ parameter to the value required, save the

parameter changes and download to the ICE Torus printer.

Please Note: Technical Guide contains descriptions for all CLARiTY Configuration Manager

parameters.

Other manuals for Ice Torus 126

Questions and Answers:

Need help?

Do you have a question about the Ice Torus 126 and is the answer not in the manual?

General