ICM Controls I3 1010HR - Changing the Lock Code; Entering Configuration Mode

11
Configuration Mode
Thecongurationmodeisusedtosetthethermostattomatchyourheating/coolingsystem.Thethermostatfunctionswithheat
pump,airconditioning,gas,oil,orelectricheatsystems.Tocongurethethermostat,performthefollowingsteps:
Press
,thenpress repeatedlyuntil isselected.
Press
toadvancefromonescreentothenext.

Note:Pressing will return you to the previous screen.
Pressthe
or tochangesettingswithineachscreen.Changesaresavedautomatically.
Toexitcongurationmode,press
.Autoexitoccursaftertwominuteswithnoiconstouched.
Tochangethelockcode,dothefollowing:
1. Press
,thenpress untilLockmenudisplays.
2. Enterthecurrentlockcodes.Tondthecurrentlockcodes,followtheinstructionsunder“CongurationandThermostat
Lock”.
3. Press
toenternewlockcodes.
4. Enternewlockcodes.
5. Press
.TheLockCodeshavebeenupdated.

Note:Upon subsequent power ups, new lock codes will display.
Changing the Lock Code