To Next PageTo Next PageWhat to do if my ICM Controls Thermostat says 'Offline!'?
If the ICM Controls Thermostat or app shows 'offline!' for more than a few minutes, unplug the thermostat from the wall plate, wait one minute, then plug the thermostat back into the wall plate.
Why is my ICM Controls I3 1010HR air conditioner still running after the room temperature is met?
If the room temperature is met, but the air conditioner is still operating, it may be because the dehumidification is set to COOL -2. The thermostat will continue to let the cooling system operate until the cooling temperature is 3°F below the setpoint or when the dehumidification setpoint is met.
What to do if ICM Controls I3 1010HR says humidifier is on, but humidity isn't rising?
If the thermostat indicates that the humidifier is operating but the humidity has not risen, check the humidifier pad and replace it if necessary.
What does 'Override' mean on my ICM Controls Thermostat display?
If 'Override' is displayed, the program schedule is in temporary override. It will return to the schedule at the next transition time.
How to stop condensation forming on windows when using ICM Controls I3 1010HR?
If condensation is forming on the windows, decrease the humidification setting on your ICM Controls Thermostat.
How to check remote sensor temperature on ICM Controls Thermostat?
To check the remote sensors temperature, press MENU, then VIEW.
How to make setpoints display all the time on ICM Controls I3 1010HR Thermostat?
To make setpoints display all of the time, press MENU, then VIEW six times.
General| Brand | ICM Controls |
|---|---|
| Model | I3 1010HR |
| Category | Thermostat |
| Language | English |
Lists items included and required tools for installation.
Details electrical ratings, power, temperature range, and system configurations.
Provides critical warnings for safe operation and installation.
Step-by-step guide for safely removing the old thermostat.
Instructions for installing batteries and maintenance recommendations.
Illustrates wiring for the I1010HR model for heating and cooling.
Illustrates wiring for the I2010HR model for heating and cooling.
Illustrates wiring for the I2020HR model for heating and cooling.
Procedure for securing the thermostat via keypad lock.
Allows selection between Fahrenheit and Celsius temperature units.
Sets the temperature difference for heating/cooling stages.
Configures whether outputs satisfy simultaneously or independently.
Sets minimum separation between heat and cool setpoints in Auto Changeover.
Selects the type of heating system for proper operation.
Sets a delay for auxiliary heat to protect the heat pump.
Defines temperature change limits and adjustable setpoint ranges.
Sets heating and cooling temperatures during vacation periods.
Calibrates the displayed room temperature to match the actual temperature.
Sets the maximum number of system cycles allowed per hour.
Selects which sensor (on-board or remote) determines room temperature.
Sets how long the fan operates after heating/cooling demand is met.
Configures fan operation for a set number of minutes each hour.
Configures the thermostat to control humidifiers or dehumidifiers.
Sets the humidity percentage difference for system activation.
Defines conditions (heat, fan, cool) required for humidity control operation.
Extends AC operation for dehumidification under specific conditions.
Configures relay function (normally open/closed) for dehumidification.
Sets fan operation during specific scheduled periods.
Sets a reminder for filter replacement based on fan run hours.
Resets the filter usage timer.
Verifies proper heating system operation by adjusting temperature settings.
Verifies proper cooling system operation by adjusting temperature settings.
Tests the fan operation in ON and AUTO modes.
Tests the humidifier's operation under various system conditions.
Tests the dehumidifier's operation under various system conditions.
