Icom IC-2300H - 2 SETTING A FREQUENCY: Tuning Step; Tuning Step Selection Procedure

Previous view
6
■ Tuning step selection
The tuning step is the smallest selectable frequency
increment you can set the operating frequency. The fol-
lowing tuning steps are selectable.
• 5 kHz • 6.25 kHz • 10 kHz • 12.5 kHz • 15 kHz
• 20 kHz • 25 kHz • 30 kHz • 50 kHz
NOTE: For convenience, select the tuning step that
matches the frequency intervals of the repeaters in
your area.
q If necessary, push [V/MH z] to select the VFO mode.
w Push [SET] to enter the Set mode.
e Push [SET] or [MONI] several times, until “TS” ap-
pears, as shown to the right.
r Rotate [DIAL] to select the desired tuning step.
t Push any key, other than [SET] or [MONI], to save
the entry and exit the Set mode.
Using the HM-133V
z If necessary, push [VFO] to select the VFO
mode.
x Push [SET] to enter the Set mode.
c Push [SET] or [ENT] several times until “TS”
appears.
v Push [Y] or [Z] to select the desired tuning step.
b Push [CLR] to save the entry and exit the Set
mode.
LOCK
S E T
ANM
MONI
DUP
LOW
T
-
SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL
PRIO
AO
BUSY
MUTE
NAR
MID
LOW
15 kHz tuning step
2
SETTING A FREQUENCY