Icom IC-2300H - 11 OTHER FUNCTIONS: Burst, DTMF, Display, and Voltage; Tone Burst, DTMF Speed, Display, and Voltage Settings

Previous view
49
11
OTHER FUNCTIONS
Tone burst D
Turn the Tone Burst function ON or OFF.
• OF : When you transmit a signal that superimposes
the CTCSS tone or subaudible tone, the squelch
tail noise may be audible on the RX side.
• ON : When you transmit a signal which superimposes
the CTCSS tone or subaudible tone, the squelch
tail noise is suppressed on the RX side.
LOCK
S E T
ANM
MONI
DUP
LOW
T
-
SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL
PRIO
AO
BUSY
MUTE
NAR
MID
LOW
Tone burst “OFF” (default)
DTMF speed D
Set the rate at which DTMF memories send individual
DTMF characters to accommodate your operating needs.
• 1 : 100 milliseconds interval; 5.0 cps speed (default)
• 2 : 200 milliseconds interval; 2.5 cps speed
• 3 : 300 milliseconds interval; 1.6 cps speed
• 5 : 500 milliseconds interval; 1.0 cps speed
LOCK
S E T
ANM
MONI
DUP
LOW
T
-
SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL
PRIO
AO
BUSY
MUTE
NAR
MID
LOW
Display type D
Set the display type for memory mode operation.
• FR : Displays the programmed frequency. (default)
• CH : Displays the memory channel number.*
• NM : Displays the channel name (if programmed)
*Only programmed memory channels can be selected.
LOCK
S E T
ANM
MONI
DUP
LOW
T
-
SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL
PRIO
AO
BUSY
MUTE
NAR
MID
LOW
LOCK
S E T
ANM
MONI
DUP
LOW
T
-
SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL
PRIO
AO
BUSY
MUTE
NAR
MID
LOW
Frequency Memory channel number
Voltage display D
Turn the Voltage Display function ON or OFF.
• OF : OFF.
• ON : The supplied voltage is displayed, when turning
ON the power. (default)
LOCK
S E T
ANM
MONI
DUP
LOW
T
-
SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL
PRIO
AO
BUSY
MUTE
NAR
MID
LOW