Icom IC-2300H - 7 SCAN OPERATION: Resume Options; Scan Resume Function Settings

Previous view
33
7
SCAN OPERATION
■ Scan Resume function
Various pause and timer options can be selected with
the Scan Resume function. The selected resume op-
tion is also used for Priority Watch. (p. 35)
q Push [SET] to enter the Set mode.
w Push [SET] or [MONI] until “SCT” or “SCP” ap-
pears.
e Rotate [DIAL] to set the desired timer:
• “SCP-2”–"SCP-20” : The scan pauses for 2 to
20 seconds, when a signal is
received.
• “SCP-HO” : When a signal is received, the
scan pauses until it disappears.
• “SCT-0”–"SCT-5” : The scan pauses, then re-
sumes 0 to 5 seconds after
the signal disappears.
• “SCT-HO” : The scan continues to pause,
even if the signal disappears.
r Push any keys other than [SET] or [MONI] to exit
the Set mode.
Using the HM-133V
z Push [SET] to enter the Set mode.
x Push [SET] or [ENT] until “SCT” or “SCP”
appears.
c Push [Y] or [Z] to select the scan resume option.
• See step e above for details.
v Push [CLR] to exit the Set mode.
NOTE: The Set mode cannot be accessed when
memory names are displayed. To set the scan re-
sume option, return to the frequency display by hold-
ing down [MONI] (ANM) on the front panel for 1 sec-
ond, or push [FUNC] then [MONI] (on the
HM-133V) to cancel the channel name display, and
then set the option as described on above.
LOCK
S E T
ANM
MONI
DUP
LOW
T
-
SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL
PRIO
AO
BUSY
MUTE
NAR
MID
LOW
When a signal is received, the
scan pauses until it disappears.
LOCK
S E T
ANM
MONI
DUP
LOW
T
-
SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL
PRIO
AO
BUSY
MUTE
NAR
MID
LOW
The scan will resume 5 seconds
after the signal disappears.