Icom IC-2300H - 7 SCAN OPERATION: Skip Channels; Skip Channel Setting

Previous view
32
7
SCAN OPERATION
■ Skip channel setting
The memory skip function speeds up scanning by not
scanning those memory channels set as skip channels.
Set skip channels as follows.
q Push [M/CALL] to select the memory mode, and
then select the memory channel to be skipped.
w Push [SET] to enter the Set mode.
e Push [SET] or [MONI] until “CHS” appears.
r Rotate [DIAL] to select “ON."
• “~” appears : The channel is skipped while scan-
ning.
t Push any key other than [SET] or [MONI], to exit the
Set mode.
Using the HM-133V
z Push [MR] to select the memory mode, and
then push [Y] or [Z] to select the channel to be
skipped.
x Push [SET] to enter the Set mode.
c Push [SET] or [ENT] until “CHS” appears.
v Push [Y] or [Z] to select “ON."
b Push [CLR] to save the selection and exit the
Set mode.
NOTES:
The Set mode cannot be accessed when memory
names are displayed. To set the skip option, return to
the frequency display by holding down [MONI] (ANM)
on the front panel for 1 second, or push [FUNC]
then [MONI] (on the HM-133V) to cancel the
channel name display, and then set the Skip function
as described above.
[i.e.]: Setting memory channel 20 as the skip channel.
LOCK
S E T
ANM
MONI
DUP
LOW
T
-
SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL
PRIO
AO
BUSY
MUTE
NAR
MID
LOW
LOCK
S E T
ANM
MONI
DUP
LOW
T
-
SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL
PRIO
AO
BUSY
MUTE
NAR
MID
LOW
The memory channel 20
is set as a skip channel.
Push [SET] or
[MONI] to select the “CHS” item.
Rotate [DIAL] to select “ON.”
Push [SET] to enter the Set mode.
LOCK
S E T
ANM
MONI
DUP
LOW
T
-
SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL
PRIO
AO
BUSY
MUTE
NAR
MID
LOW
LOCK
S E T
ANM
MONI
DUP
LOW
T
-
SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL
PRIO
AO
BUSY
MUTE
NAR
MID
LOW
LOCK
S E T
ANM
MONI
DUP
LOW
T
-
SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL
PRIO
AO
BUSY
MUTE
NAR
MID
LOW
The memory channel 20
is set as a skip channel.
Push to select the “CHS” item.
Push to select “ON.”
Push to enter the Set mode.
LOCK
S E T
ANM
MONI
DUP
LOW
T
-
SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL
PRIO
AO
BUSY
MUTE
NAR
MID
LOW
/
/
[i.e.]: Setting memory channel 20 as the skip channel,
using the HM-133V.