Icom IC-2300H - 9 DTMF MEMORY ENCODER: Speed; DTMF TX Speed Settings

Previous view
38
9
DTMF MEMORY ENCODER
■ DTMF TX speed
The transmitting speed of DTMF code can be set to ac-
commodate your operating needs.
q Hold down [ ] for 1 second to turn OFF the power.
w While holding down [LOCK] (SET) and [ ] for 1
second, to turn ON the power to enter the Initial Set
mode.
e Push [SET] or [MONI] until “DTD” appears.
r Rotate [DIAL] to select the desired transmitting
speed, as shown in the table below.
t Push [ ] to exit the Initial Set mode.
cps=characters/second
DISPLAY INTERVAL SPEED
DTD- 1 100 milliseconds 5.0 cps
DTD- 2 200 milliseconds 2.5 cps
DTD- 3 300 milliseconds 1.6 cps
DTD- 5 500 milliseconds 1.0 cps
LOCK
S E T
ANM
MONI
DUP
LOW
T
-
SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL
PRIO
AO
BUSY
MUTE
NAR
MID
LOW
The display shows the
fastest DTMF speed is
selected.