5
2
BASIC OPERATION
■ Turning power ON
➥ Push [ ] to turn the power ON.
■ Channel selection
➥ Push []/[]to select the desired operating channel.
• While pushing and holding []or [], the displayed channel
changes continuously until channel number “01” appears.
• When displayed channel stops at channel number “01”, beeps
are emitted.
D Private channel selection
q Push [
O
] (Bank/Func) to enter the channel bank selection
mode. Then select the desired bank with []/[]. Push
[
O
] (Bank/Func) again to set the bank.
w Push []/[]to select the desired operating channel in
sequence.
NOTE: The selected channel is retained even when the
transceiver is turned off.
About the password prompt:
If the transceiver is programmed for a start up passcode,
enter the specified 4-digit code.
(The optional CS-400PRO
CLONING SOFTWARE
is required.)
• The keys in the table below can be used for password input:
• The transceiver detects numbers in the same block as identical.
Therefore “01234” and “56789” are the same.
When the “PASSWORD” indication does not clear after
entering 4 digit code, the enter code number is incorrect. In
this case, turn the power off and start over.
KEY
NUMBER
01234
56789
IC-400PRO.qxd 03.6.19 6:13 PM Page 5 (1,1)
To Next Page
Loading...
Need help?
General
