17
6
SELCALL OPERATION
■ General
In addition to the group mode operation for silent stand-by,
the SelCall operation is available. SelCall is an abbreviation
for “Selective Calling”. In Group mode operation, there are 51
ways to make an individual call with CTCSS frequencies ver-
sus 100,000 ways to make an individual call with Selcall using
5tone.
SelCall allows you to selectively call another unit that is oper-
ating on the same channel.
SelCall can also call the entire group on that channel using
group call code.
The caller station code/name, status message, Answer Back
function, automatic scan start function, etc. are available with
SelCall operation. A variety of functions are available depend-
ing on the setting with the CS-400PRO
CLONING SOFTWARE
.
See the help file for setting details.
■ Calling operation
D TX code channel selection
The [MONI] (Call) key (in Function mode) enables you to
change the TX code channel with []/[]keys.
TX code is transmit SelCall code. Max. 32 TX code chan-
nels can be pre-programmed into the IC-400PRO using
the optional CS-400PRO
CLONING SOFTWARE
.
To select a TX code channel:
q While in Function mode, push [MONI] (Call) for 1 sec. to
enter the TX code channel selection mode.
• Push [
O
]
(Bank/Func)
for 1 sec. to enter the transceiver into
Function mode.
w Push []/[]to select the desired TX code channel.
To Next Page
