27
7
OTHER FUNCTIONS
■ Set mode
Set mode allows you to change seldom used common set-
ting for the transceiver, or individual setting for the operating
channel. In this case you can “customize” transceiver opera-
tion to suit your preferences and operating style.
To enter the common setting for the transceiver, or individ-
ual setting, push the appropriate key in step t below.
Entering the Set mode:
q Push [
O
] (Bank/Func) to enter the channel bank selection
mode. Then select the desired channel bank with []/
[]key. Push [
O
] (Bank/Func) again to exit the channel
bank selection mode.
w Push []/[]to select the desired channel when you
change the individual setting.
*The bank and channel can be selected after entering Set mode.
e Push [
O
]
(Bank/Func)
for 1 sec. to enter the Function
mode.
r Push for 1 sec. again to enter the Set mode.
t Push [SCN] for 1 sec. to change the common setting, or
[MONI] for the individual setting.
y Push [SCN]/[MONI] (the same key that you pushed in
step t) to select the appropriate item. Then, push []/
[]to set the desired level/mode or [DUP] to turn the func-
tion ON or OFF (depending on the selected item).
u After pushing [SCN]/[MONI] (the same key that you
pushed in step t) for 1 sec., push [
O
] for 1 sec. to exit Set
mode.
NOTE: The displayed items can be changed depending on
the pre-setting via the optional CS-400PRO
CLONING SOFT
-
WARE
.
See next page for Set mode flow chart.
To Next Page
