13
4
SCAN OPERATION
■ Repeater search scan
The repeater search scan is not only searching for a signal
on the repeater channels, but also access a repeater by
transmitting automatically in sequence.
Thus the repeater search scan function searches an available
repeater in the area even if the repeater is not in use.
IMPORTANT!:
A microphone should be on hook to start scanning.
The repeater search scan detects a signal on the repeater
output, CH 1 to 8, only. Therefore, repeater availability can-
not be guaranteed even the repeater scan is stopped,
because the scan will stop if any activity is detected. (The
scan is cancelled when receiving a signal, such as stations
communicating in simplex operation on a repeater output
channel.)
q Push [SCN] (Scan Start/Stop) for 1 sec. to enter the scan
type selection mode.
w Push []/[]to select the repeater scan.
e Push and hold [SCN] (Scan Start/Stop) to return to Normal
mode.
• “RS” appears when the repeater scan is selected.
r Push [SCN] (Scan Start/Stop) to start the repeater scan.
• See the flow as described at right for repeater search scan
details.
t When receiving a signal on the repeater channel, scan
stops.
• 3 high beeps sound when receiving a signal, and 3 low beeps
sound when no signal receiving.
y Push [SCN] (Scan Start/Stop) to cancel the scanning man-
ually.
To Next Page
Loading...
