Icom IC-400PRO Instruction Manual

11
4
SCAN OPERATION
■ Open scan
Open scan searches for being transmitted signals automati-
cally and makes it easier to locate new stations for contact or
listening purposes.
IMPORTANT!:
• A microphone should be on hook to start scanning.
• During open scan, transmission is inhibited except on a
busy channel.
q Push [SCN] (Scan Start/Stop) for 1 sec. to enter the scan
type selection mode.
w Push []/[]to select the open scan.
e Push [SCN] (Scan Start/Stop) for 1 sec. to return to
Normal mode.
- “OS” appears besides the channel number indication.
r Push [SCN] (Scan Start/Stop) to start the open scan.
t When receiving a signal, scan pauses and resumes
according to the selected scan resume condition. (p. 10)
y Push [SCN] (Scan Start/Stop) to cancel the scan.
Start channel
Open scan setting
Open scan
Push [] or []
Push [SCN] for 1 sec.
Previously selected scan type
is displayed.
IC-400PRO.qxd 03.6.19 6:13 PM Page 11 (1,1)

Icom IC-400PRO Specifications

General

Mode	FM
Output Power	5W
Receiver Sensitivity	0.25 μV (12dB SINAD)
Voltage	7.2 V
Weight	320 g
Channel Spacing	25/12.5 kHz
Operating Voltage	7.2V DC nominal