9
4
SCAN OPERATION
■ Scanning preparation
IC-400PRO scans all tagged channels, and can be selected
so the scan resume condition is a pause or timer scan.
Therefore, these items must be set before starting a scan
(except the repeater search scan). These items must be set
for each scan type (open, group and priority) independently.
D Setting scan tag
q Select the desired channel. (p. 5)
w Push [SCN] (Scan Start/Stop) for 1 sec. to enter the scan
type selection mode.
e Push []/[]to select the desired scan type.
• Open, group, priority and repeater search scans are available.
r Push [SCN] (Scan Start/Stop) to select the tag setting ON
and OFF.
• “
S
” appears when the tag setting ON (The channel is set as a
scan channel).
t Push [SCN] (Scan Start/Stop) for 1 sec. to return to
Normal mode.
To speed up scanning:
For open scan, cancel the tag channel setting to skip unde-
sired channels such as usually busy channels.
For group scan, set only often-used channels as tag chan-
nels.
All memory channels may be set as tag channels by
default.
To Next Page
Loading...
