12
4
SCAN OPERATION
4
■ Group and priority scans
Group and priority scans repeatedly watch a priority channel
while scanning specified channels. This is useful when wait-
ing for a call on the priority channel or several specified chan-
nels.
Group and priority scans behave differently when transmit-
ting. Group scan can only transmit on a busy channel, and
priority scan can only transmit on a priority channel or start
channel.
IMPORTANT!:
A microphone should be on hook to start scanning.
q Push [SCN] (Scan Start/Stop) for 1 sec. to enter the scan
type selection mode.
w Push []/[]to select the group or priority scan.
e Push [SCN] (Scan Start/Stop) for 1 sec. to return to
Normal mode.
- “GS” or “PS” appears besides the channel number indication.
r Select the priority channel if desired.
- Push []/[]to select the desired channel.
- Push [DUP] (Dup/Pri) for 1 sec. to set the channel as a priority
channel.
t Push [SCN] (Scan Start/Stop) to start the scan.
y When receiving a signal, the scan pauses and resumes
according to the selected scan resume condition. (p. 10)
u Push [SCN] (Scan Start/Stop) to cancel the scan.
To Next Page
Loading...
