22
7
OTHER FUNCTIONS
6
7
These functions have an answer back feature, and allows you
to confirmation of whether or not a call has reached the
receiving party even if the operator is temporarily away from
the transceiver. The Smart-Ring is for manual, and the ATS
is for automatic confirmation. Both functions are compatible
with the IC-40Jr and IC-4088S.
[ATS/S-ring] must be assigned to the desired programma-
ble key using the optional CS-400PRO
CLONING SOFTWARE
.
D Smart-Ring
q Set the same CTCSS frequency (or group code) for all of
the group transceivers. (See p. 15)
w Push [ATS/S-ring].
•A beep is emitted and “” appears on the display.
• When a member of a specific group answers a call, “” blinks.
• When no answer back is received, the transceiver emits short
faint beep tones.
e Push [PTT] to answer and to stop the flashing.
NOTE: This function is available only when the called sta-
tion has set the same CTCSS frequency (or group code)
and the same operating channel as you.
D ATS
➥ Push [ATS/S-ring] for 1 sec. to turn the function ON.
•The transceiver starts to send a searching signal every 60 sec.
•“ ” and “” appear on the display when the function is activat-
ed.
- When the transceiver receives an answer back signal, “” stays
on the display until the next search transmit.
- If no reply is received, “” blinks until the next search transmit.
NOTE:
• The setting at left is for the calling station only. A called
party automatically sends an answer back signal without
any presettings. All IC-400PRO’s operating on the same
operating channel will answer back to the call in the sur-
roundings communications area.
• When the CTCSS frequency (or group code) is set to the
IC-400PRO, this function is available only for the same
frequency (code) setting.
To Next Page
Loading...
